TROUBLESHOOTING
46
En
In case of a transmission error without a status message appearing on the front panel display of this unit, check the connection to your
iPod (refer to page 11).
There is noise
interference (e.g. hiss,
crackle or jitter).
The indoor DAB/FM antenna needs to
be repositioned.
Readjust the position of the indoor DAB/FM
antenna.
The DAB signals are too weak.
Use the TUNE AID feature to locate the best
positioning of the indoor DAB/FM antenna and this
unit for optimal DAB reception.
The DAB station
information does not
appear or is
inaccurate.
The DAB station is temporarily out of
service, or the DAB station information
is not provided by the DAB broadcaster.
Contact the DAB broadcaster.
—
FM reception
Problem
Cause
Remedy
Page
FM stereo reception is
noisy.
The antenna is connected improperly.
Check the antenna connections.
The characteristics of FM stereo
broadcasts cause this problem when the
transmitter is too far away or the
antenna input is poor.
Try using a high-quality directional FM antenna.
—
Switch to monaural mode.
The desired station
cannot be tuned into
with the automatic
tuning method.
The signal is too weak.
Use a high-quality directional FM antenna.
—
Use the manual tuning method.
The preset selecting
function does not
work.
The preset (memory) has been erased.
Preset radio stations again.
There is distortion,
and clear reception
cannot be obtained
even with a good FM
antenna or an outdoor
antenna.
Multipath reflection or other radio
interference has occurred.
Change the height, direction, or placement of the
antenna.
—
iPod
Note
Status message
Cause
Remedy
Page
READING
This unit is in the middle of recognizing
the connection with the iPod.
If the message continues to appear on the front panel
display and playback does not start, connect the iPod
again.
—
UNKNOWN
There is a problem with the signal path
from the iPod to this unit.
Connect the iPod again.
The iPod being used is not supported by
this unit.
Only iPod classic, iPod nano (2nd, 3rd, 4th, 5th and
6th generation), iPod touch (1st, 2nd, 3rd, and 4th
generation), iPhone, iPhone 3G/3GS, iPhone 4, and
iPad are supported.
The iPod software is out of date.
Update the iPod software version to the latest.
—
STOP
The play back of the iPod is finished.
For example, all the songs in the
selected album have finished being
played back.
NO iPod
The iPod was disconnected from this
unit.
Connect the iPod and this unit by a USB cable
correctly.
Problem
Cause
Remedy
Page
