m
Mounting the speakers on a wall
The speakers can also be hung on the wall.
Fasten screws into a firm wall or wall support as shown in
the figure, and hang the slits on the rear of the speaker on
the protruding screws.
* Make sure that the screws are securely caught by the
slits.
Warning
●
Each speaker weighs 0.3 kg (0.6 lbs.). Do not mount them
on thin plywood or a wall with soft surface material. If
mounted, the screws may come out of the flimsy surface
and the speakers may fall. This could damage the speakers
and cause personal injury.
●
Do not install the speakers on a wall with nails, adhesives,
or any other unstable hardware. Long-term use and
vibrations may cause them to fall.
●
To avoid accidents resulting from tripping over loose
speaker cables, fix them to the wall.
m
Placing the center speaker on top of the
monitor
A speaker used for the center speaker can be placed on top
of the monitor. Follow one of the two procedures below for
placing a speaker on top of the monitor.
Placing the center speaker on top of the monitor
by using the provided fastener
First remove the stand from the speaker, and attach the
provided fastener at the bottom of the speaker and on top of
the monitor to prevent the speaker from falling.
*
This is the recommended method for placing a speaker
on top of the monitor. If discoloration of picture occurs, or
you need the speaker stand to adjust the speaker angle
on top of the monitor, you can select the following
method.
Tapping screw (4 mm)
(Available in hardware stores)
50 mm
Min.
20 mm
4 mm
W
all/ w
all
suppor
t
Note
Do not place the speaker on top of the monitor with an
inclination of more than 10 degrees.
Placing the center speaker on top of the monitor
with the speaker stand attached to the speaker
In this method, you need to fix the speaker cable on the
monitor by using the provided cable holder to prevent the
speaker from falling.
1
Remove the backing sheet from the holder, and attach
the holder on top of the monitor by pressing it down
forcibly. (The top of the monitor must be cleaned
beforehand.)
2
Tie the speaker cable to the holder firmly with a provided
vinyl-coated wire (which is originally used for bundling
the speaker cables) as shown below.
Note
Though this speaker is a magnetically shielded type, there
may be some influence on the monitor picture depending on
the type of monitor or the placement of the speaker. In such a
case, place the speaker further apart from the monitor until
there is no influence on the monitor picture.
Fastener
10
&
10
&
Cable holder
Vinyl-coated wire
E-
2
