Yamaha NS-SW1000, Owner'S Manual

Page: 8 / 131

5
En
Choose one of the following connection methods most suitable for your audio system.
Choose this method if your amplifier has line output (pin jack) terminal(s).
(
)
page 5)
Choose this method if your amplifier has no line output (pin jack)
terminals. (
)
page 6)
• Unplug the subwoofer and other audio/video components before making connections, and do
not plug them in until all connections are completed.
• Connecting methods and terminal names on your component (such as an amplifier or receiver)
may be different from those used in this book. Please refer to the owner’s manual that came
with your component.
• All connections must be correct, that is to say L (left) to L; R (right) to R; “+” to “+” and “–” to “–”.
Audio signals input from the /MONO and INPUT 2 terminals on the subwoofer will not be output from the OUTPUT (TO SPEAKERS) terminals.
Connecting one subwoofer
Connect the SUBWOOFER (or LOW PASS, etc.) terminal on the rear of the amplifier (or
AV receiver) to the
/MONO INPUT2 terminal of the subwoofer using a commercially-
available Mono pin cable (
1
).
Alternatively,
When connecting the subwoofer to the SPLIT SUBWOOFER terminals (featuring L and R
channels) on the rear panel of the amplifier, use
a commercially-available Audio pin
cable (
2
) to connect the /MONO INPUT2 terminal to the “L” side, and the INPUT2
terminal to the “R” side of the SPLIT SUBWOOFER terminals.
Connecting two subwoofers
Connecting to the INPUT3 (LFE) terminal
If your amplifier (or receiver) can cut off high frequencies
from signals sent to the subwoofer, connect the amplifier to
the subwoofer’s INPUT3 (LFE) terminal.
This will promote higher sound quality because the signal
routing in the subwoofer is shortened by bypassing the built-
in HIGH CUT circuit.
CONNECTIONS
1
2
Note
Connecting to line output (pin jack) terminal(s) of the amplifier
1
Note
1
2
1
Mono pin cable
2
Audio pin cable
Subwoofer
Amplifier or
receiver
1
1
Mono pin cable
1
Subwoofer
Subwoofer
Amplifier or
receiver