Yamaha MT1X, Authorized Product Manual

Page: 32 / 42

*Explanation diagram for steps to
4. Setting input levels
Set input select switch 3 to “MIC/LlNE”.
Set both input fader 3 and the MASTER fader to “7”.
Slide gain control 3 in the “MIC” direction, stop-
ping when the “+3” LED indicator on the. level
meter third from the left flashes occasionally on
music peaks. (Setting the same as when the vocals
were initially recorded is recommended.)
5. Adjusting the recording level and sound
characteristics
Using the equalizer controls for channel 3, adjust
for the desired sound characteristics. It’s a good
idea to set them where they were for the initial
recording.
After setting the equalization, set the recording
level, preferably at the same level as the initial
recording.
6. Recording
Press the PAUSE switch to start the recording.
“Punch-in” when you reach the passage that must
be redone by sliding the RECORD SELECT switch
to the “3” position. When using the FS-1, press on
the foot switch. In both cases, the REC indicator
will light.
“Punch-out” when you have finished redoing the
passage by sliding the RECORD SELECT switch to
the “OFF” position. When using the FS-1, press on
the foot switch again. In both cases, the REC in-
dicator will begin flashing.
Rewind the tape.
— Punch-in/Punch-out Completed —
7. Post recording check
Press the PLAY switch to make sure the passage
was redone correctly.
Return all controls and switches to their normal
positions, and rewind the tape. We’re now ready for
mixdown recording.
3 0