TAPE OUT Jacks 1 — 4
The four TAPE OUT jacks are direct outputs from the
corresponding tracks of the MT120 recorder. These RCA
pin type jacks make it possible to feed the output from
the four recorder tracks to an external mixing console.
The TAPE OUT jacks can also be used to feed each of
the recorder’s tracks to external signal processors, the
output of which can then be returned to the MT120’s
mixer inputs.
STEREO OUT R and L Jacks
These are the main outputs from the MT120, delivering
the stereo output signal from the MT120 mixer section.
The RCA pin-type STEREO OUT jacks can be con-
nected to a stereo sound system for monitoring and
listening. You can record a mixdown of your tape tracks
when these jacks are connected to the inputs of a stereo
recorder.
REMOTE CONTROL connector
MONITOR OUT R and L Jacks
These jacks output the same signal fed to the PHONES
jack (at line level). Control the level (volume) of the
output using the MONITOR/PHONES control. The
MONITOR OUT jacks can be connected to a stereo
sound system for monitoring and listening. They are
RCA pin type jacks.
POWER Switch
Press the POWER switch once to turn power ON, a
second time to turn power OFF. When the power is ON,
the POWER LED above the LED peak meters on the
MT120 top panel will light. Make sure that the input faders
are set to “0” and the AUX RETURN level control is set
to “MIN” before turning power on.
[Note]
When the power of the unit is turned on, a
initializing function will be activated so that for a
period of approximately 4 seconds it can not be
operated. During the initialisation process the PLAY
indicator will blink slowly.
When the optional Remote Controller RCM1 is connected, tape transport operations
(REC/PAUSE, PLAY, REW, FF, STOP) can be performed from a distance.
9
