Instrument an
d
control functions
4-9
4
Avera
g
e spee
d
mo
d
e
This shows the vehicle’s average trav-
eling speed since it was last reset. To
reset the average speed display, push
the “RESET” button for one second.
Shift li
g
ht control mo
d
e
The shift light has four settings which
can be adjusted.
z
Flashing pattern: choose whether
or not the shift light will come on,
and whether it will flash or light
continuously.
z
Activation point: select the engine
speed at which the shift light is ac-
tivated.
z
Deactivation point: select the en-
gine speed at which the shift light
is deactivated.
z
Brightness adjustment: adjust the
brightness of the shift light.
To adjust the shift light
1. Turn the main switch off.
2. Push and hold the “SELECT” but-
ton.
3. Turn the main switch on, and then
release the “SELECT” button after
five seconds. After that, push the
“SELECT” button again. The
multi-function meter unit will enter
the shift light control mode.
To set the flashing pattern
1. Push the “RESET” button to select
one of the following flashing pat-
tern settings:
z
On: the shift light will come on
continuously when activated.
(This setting is selected when
the shift light stays on.)
z
Flash: the shift light will flash
when activated. (This setting
is selected when the shift light
flashes four times per sec-
ond.)
z
Off: the shift light is deactivat-
ed; in other words, it does not
come on or flash. (This setting
is selected when the shift light
flashes once every two sec-
onds.)
2. Push the “SELECT” button to con-
firm the selected flashing pattern.
Next the shift light activation point
can be set.
To set the shift activation point
TIP
z
The tachometer will show the cur-
rent activation point.
1. Average speed display
1. Shift light
2. Brightness level display
1
2
1
UB7DE0E0.book Page 9 Tuesday, September 18, 2018 3:25 PM
