2-25
INSP
ADJ
1
1
2
•
Install the oil drain bolt
1
.
Oil drain bolt
1
:
16 Nm (1.6 m • kg, 11 ft • lb)
Recommended oil:
Gear oil API “GL-3” SAE #75 or #80
Oil capacity:
0.25 L (8.8 Imp oz, 8.5 US oz)
Chain slack adjustment
1. Adjust:
•
Drive chain slack
Adjustment steps:
•
Loosen the locknut
1
.
•
Turn the adjusting bolt
2
in until it is finger
tight.
•
Tighten the locknut.
TRACK TENSION ADJUSTMENT
WARNING
A broken track or track fittings, and debris thrown
by the track could be dangerous to an operator or
bystanders. Observe the following precautions.
•
Do not allow anyone to stand behind the
machine when the engine is running.
•
When the rear of the machine is raised to allow
the track to spin, a suitable stand must be used
to support the rear of the machine. Never allow
anyone to hold the rear of the machine off the
ground to allow the track to spin. Never allow
anyone near a rotating track.
•
Inspect the condition of the track frequently.
Replace the track if it is damaged to a level
where the fabric reinforcement material is
visible.
•
Never install studs (cleats) closer than three
inches to the edge of the track.
T
R
.
.
DRIVE CHAIN/
TRACK TENSION ADJUSTMENT
SEJ2540
SEJ2535
Summary of Contents for MM600D
