27
English
Mode Functions
You can assign the AUX 1/2 signals (routed in the Mixer Input section) to any mLAN channel.
1. Press the [Mixer 2] button.
2. Press the [AUX 1] or [AUX 2] button.
3. Use the [
PAGE
] button to select a parameter you wish to set.
4. Use the [+1/ENTER] and [–1/EXIT] buttons or the [VALUE] dial to select the names of the
devices and parameter values.
[AUX Out Device/Nickname]
Use the [AUX Out Device/Nickname] parameter to specify the name of the device you wish to
assign as the destination of the AUX signals. If you are not connecting any devices, select
“Unconnected.”
[AUX Out Plug]
Select an AUX send “Plug” from the mLAN Plugs (virtual plugs) on the selected device. If the
device does not have an appropriate mLAN Plug, “No Source (Destination) Plug” appears.
You can select multiple destinations. If multiple devices are connected to the
network, the [Device/Nickname] and [Plug] parameter screens indicate the
number of connected devices in the lower left corner of the display. When
you press the [PAGE
] button repeatedly, this number increments and the
parameter setting changes accordingly.
[Link (Link Switch)]
When this switch is turned on, the level settings for AUX 1 and AUX 2 become the same. The
parameter value of the channel for which the Link Switch is turned on will be applied to the
other channel.
When the Link Switch is turned on, “ ” appears in the lower left corner of the display.
Value: On, Off
Settings for the Mixer Output Section: [Mixer 2] -
[AUX 1/2]
NOTE
mLAN8P-(E).book Page 27 Wednesday, October 11, 2000 11:03 AM
