MG12XUK Owner’s Manual
13
Controls and Functions
u
Equalizer (EQ) knobs
Adjust the sound quality by using the [HIGH] (high fre-
quency band), [MID] (middle frequency band), and
[LOW] (low frequency band) knobs. If you do not need
to adjust the sound quality, set the knob to the “
” (flat)
position.
i
[FX] (effect) knobs
Adjusts the volume sent from each channel to the inter-
nal effect and the [FX SEND] jack.
o
[PAN] knobs (channels 1 to 6)
[BAL] knobs (channels 7/8 and 9/10)
[PAN/BAL] knobs (channels 11/12)
[PAN]:
Adjusts the volume balance of each channel
sent to the stereo bus, and determines the positioning of
the sound image between left and right (stereo L/R).
When the knob is located at the 12 o’clock position, the
channel’s sound will be sent to the stereo bus channels
(L and R) at the same volume. In this case, the sound
image is positioned at the center.
[BAL]:
Determines the volume balance of the stereo
channels (7/8 to 11/12) (L/R) sent to the stereo bus.
When the knob is located at the 12 o’clock position, the
sound of the stereo channels will be sent to the stereo
bus channels (L and R) at the same volume respec-
tively.
[PAN/BAL]:
Provides both [PAN] and [BAL] functions.
You can use this as a [PAN] control when sound is input
to the [LINE] (L/MONO) jack, and as a [BAL] control
when sound is input to both [LINE] (L) and [LINE] (R)
jacks.
!0
[PEAK]LED
Lights when the volume of input and/or post-equalizer
sound is too high (when reaching 3 dB below clipping).
If it is lit frequently, turn the [GAIN] knob
r
to the left to
lower the volume.
!1
[LEVEL] knobs
For adjusting the volume balance among the channels.
Generally, set this to the “
” position.
!2
[TO MON
/TO ST
]switch
For selecting the output destination of the input sound
to channels 11/12. Normally set this switch to [TO
ST
]. When you use the unit with a computer con-
nected to the [USB 2.0] terminal, toggle this switch
according to your specific application, referring to the
chart in “Rear panel USB section.”
!3
[LINE] stereo input jacks (channels 7/8 to 11/12)
For connecting line-level devices such as an electric
keyboard or an audio device. These jacks support
phone plugs and RCA-pin plugs.
NOTE
Regarding input to channels 7/8 and 9/10, if both phone and
RCA-pin jacks are used at the same time, the phone jack will
take priority.
!4
[LINE
/USB
] switch
Toggles the sound source input to channels 11/12.
When the switch is set to [LINE
], the source will be
the [LINE] stereo input jack
!3
, and when set to
[USB
], the source will be the [USB 2.0] terminal.
Summary of Contents for MG12XUK
Page 26: ...MG12XUK Owner s Manual 26 ...
Page 27: ......
