Auto Punch In/Out
39
MD8—Owner’s Manual
Auditioning Your Takes
Here is how to audition all the takes you recorded:
1. At the
NEXT TAKE
message that appears when the MD8 returns to the
Pre-Roll point, use the DATA dial to select
MONI TAKE
.
2. Press the [ENTER] button.
The display now shows the message
TAKE X MONI
(where “X” represents the number of
the last take you recorded).
3. Use the DATA dial to select the Take you want to audition.
Here, the options include all takes you have just recorded, as well as
ORIGIN
. This is the
original recording, while all recordings marked with “Take” are new versions that may be
used instead of the original.
4. Press the [PLAY] or [ENTER] button to start playback of the selected Take
(or Original).
The
TAKE X Play
(or
ORIGIN Play
) message appears on the display while the MD8
plays back the selected take. After playing through the excerpt, playback stops at the Post-Roll
point.
5. Go back to step (3) to select another Take.
6. If, after listening through the takes, you decide you haven’t yet played
(or sung) that killer solo, press [EXIT] to return to the
NEXT TAKE
message
and record a few more takes (see page 38).
Choosing a Take
After auditioning your takes (and possibly recording a few more), you will no doubt decide
to use one of them. Here is how to paste the desired take into your song (which you haven’t
done so far):
1. At the
TAKE X: MONI
message, use the DATA dial to select the take you
want to paste into your song.
2. Turn the CURSOR shuttle to the right to make the
MONI
message flash.
3. Use the DATA dial to select
FIX
.
The display now reads
TAKE X FIX
(where “X” represents the number of the take you
have just selected).
4. Press the [ENTER] button.
As “fixing” the take cannot be undone, the display now asks you whether you really want to
substitute it for the original version (
FIX TAKE?
).
5. Press [ENTER] to insert the selected take into the track, or [EXIT] if you
have changed your mind.
The display now reads
TAKE FIX
, which means that the selected take is copied to the posi-
tion between the Punch In and Punch Out points, thus replacing the original recording.
After inserting the take, the MD8 leaves Multi Take Auto Punch In/Out mode and erases all
remaining takes as well as the original version. As stated above, these cannot be recalled.
Note: It is not possible to permanently save all takes. You have to choose one of them before
leaving Multi Take Auto Punch mode by pressing [AUTO PUNCH I/O], or before switch-
ing off the MD8. If you do not perform the following steps, the MD8 returns to the excerpt
marked as
ORIGIN
(i.e., the original recording).
Note: Selecting a take here will erase the original excerpt as well as all remaining takes.
