6D03F1X
70
NOTE:
Wrap the removed pipe joint
b
in a rag.
12. Connect the PTT motor leads to the bat-
tery terminals to extend the trim ram, and
then measure the hydraulic pressure.
13. Reverse the PTT motor leads between
the battery terminals to fully retract the
trim and tilt rams.
14. Remove the oil pressure gauge
2
.
15. Install the pipe joint
b
, and then tighten
the pipe joints to the specified torque.
16. After measuring the hydraulic pressure,
connect the PTT motor leads to the bat-
tery terminals to fully extend the trim and
tilt rams.
17. Remove the reservoir cap, and then
check the fluid level in the reservoir.
PTT oil pressure gauge assembly:
90890-06580
Hydraulic pressure (up):
11.3–13.3 MPa (113–133 kgf/cm
2
)
T
R
.
.
Pipe joint
3
:
15 N·m (1.5 kgf·m, 11.1 ft·lb)
Power trim and tilt unit