GX-700/GX-700VCD
GX-700/VCD
7. Removal of Tray & Traverse Unit
a. Remove 4 screws (
!2
) and then remove the Clamp Bracket in Fig. 10.
b. Remove 2 screws (
!3
) and then remove the Tray Brackets in Fig. 10.
c. Push the Friction Arm ( the bottom side of the CD Mechanical Unit ) with a screwdriver or the like and pull out the Tray
forward as in Fig. 10.
d. Remove 4 screws (
!4
) and take out the Slider in Fig. 11.
e. Disconnect the Flat Connecting Cable ( 16P ) and connectors ( 6P ).
f. Remove the Traverse Unit in Fig. 11.
!2
CD Mechanical Unit
Friction
Arm
Clamp Bracket
Fig. 11
●
Precaution for Installation of Tray
Be sure to fit the shaft of the Friction Gear into
the groove in the Tray.
●
Installation of Traverse Unit & Slider
a. Fit the Traverse Unit into the Chassis.
b. Turn the Cam Gear until its Guide Pin comes to the
position as shown in Fig. 11.
c. Fit the Slider into the Traverse Unit. Set the Spring of
the Slider so that it holds down the Guide Pin of the
Cam Gear (as shown in Fig. B).
(Press the Spring of the Slider once and release it,
and it will hold down the Guide Pin of the Cam Gear.)
d. After installation, check that the Clamp moves up and
down by turning the Load Gear.
Fig. B
Tray
Tray Bracket
!3
Spring
Spring
Spring
Load Gear
FRONT
Groove
Guide Pin
OK
NG
Tray
Bracket
Friction
gear
Shaft
Tray
Slider
Traverse
Unit
Guide
Pin
Cam Gear
Fig. 10
!4
no marking
side
!4
Guide Pin
Cam Gear
Traverse
Unit
Spring
Slider
Fig. A
11
!2
