8-37
Rear axle boot
The axle boot must be checked for damage at the
intervals specified in the periodic maintenance and
lubrication chart. Check the axle boot for tears or
damage. If any damage is found, have them re-
placed by a Yamaha dealer.
Tightening torque:
Adjusting bolt (rear brake caliper):
0.3 Nm (0.03 m·kgf, 0.22 ft·lbf)
Locknut (rear brake caliper):
16 Nm (1.6 m·kgf, 11.6 ft·lbf)
WARNING
Operating with improperly serviced or adjusted
brakes could cause the brakes to malfunction,
resulting in reduced braking performance.
This could increase the chance of a collision or
accident. After adjusting the parking brake free
play, block the rear of the ATV off the ground
and spin the rear wheels. Check to make sure
there is no brake drag. If brake drag is noticed,
perform the adjustment again.
1. Rear axle boot
1
Brake light switches
The rear brake light, which is activated by the
brake pedal and brake lever, should come on just
before braking takes effect.
The brake light switch for the brake pedal can be
adjusted as follows, but the front brake light switch
should be adjusted by a Yamaha dealer.
1. Remove the right footboard. (See page 8-15.)
8
Summary of Contents for Grizzly 300
