Yamaha FZS600 2000, Supplementary Service Manual

Page: 24 / 41

–16–
CABLE ROUTING
SPEC
37
Clutch cable
38
Starter cable
39
Ground lead
40
Box
41
Fan motor lead
42
Rectifier / regulator lead
13
43
Handlebar switch lead (left)
44
Main switch lead
45
Wire harness
46
To taillight
47
Rear fender
48
Clamp
A Tighten the ground lead and the
thermostat housing together
with a bolt.
B Pass the reservoir hose left side
of thermo stat housing.
C Do not fasten the high tension
cord #4 with locking tie.
D Use a plastic band to fasten the
high tension cord #3, #4.
E Fuel pump lead comes over.
F Pass the rear brake switch lead
and battery negative lead under
the coolant reservoir tank, be-
tween the reservoir hose and the
battery, then are connected at
the right side of the battery.
G Pass the rear flasher lead (R)
through the rear fender.
H Pass the rear flasher lead (L)
through the rear fender.
I Pass the wire harness through
the groove of the rear fender.
J Wire harness shouldn’t come
top of the rear fender rib.