Yamaha FZS600 2000, Supplementary Service Manual, Page: 21 / 41

–13–
CABLE ROUTING
SPEC
C Pass the T.P.S lead as shown,
then install cover to the air filter
case.
D Use a plastic clamp to fasten to-
gether the throttle cables, head-
light lead, handlebar switch
(right) and speed sensor lead.
E Use a plastic locking tie to fasten
the handlebar switch (right) and
brake hose to the right front fork
inner tube.
F Pass the throttle cable, with the
pull side up, through the center
of the clamp.
G Pass the throttle cable through
the guide wire installed to the
handle crown.
H To front cowling.
I Pass the main switch lead under
the throttle cables, headlight
lead, handlebar switch lead
(right) and speed sensor lead,
then insert it right side of the box.
J Pass the throttle cable under the
box.
K Pass the reservoir tank over flow
hose and fuel tank drain hose
through the cable holder.
L To coolant reservoir tank.
M Pass the battery negative (–)
lead inside of the reservoir hose.
N Use the plastic clamp to fasten
together the rear brake switch
lead and the frame.
The latch of the clamp must face
the outside of the body.