3-7
E
EMU00209
Controls
●
Check throttle, shift, and steering for
proper operation before starting the
engine.
●
The controls should work smoothly, with-
out binding or unusual free play.
●
Look for loose or damaged connections.
●
Check operation of the starter and stop
switches when the outboard motor is in
the water.
EMU00210
Engine
●
Check the engine and engine mounting.
●
Look for loose or damaged fasteners.
●
Check the propeller for damage.
EMU01436
CHECKING THE ENGINE OIL LEVEL
1) Put the outboard motor in an upright
position (not tilted).
2) Pull out the oil dipstick and wipe it clean.
3) Completely re-insert the dipstick and
pull out it again.
4) Check the oil level using the dipstick to
be sure the level falls between the upper
and lower marks. Fill with oil if it is below
the lower mark, or drain to the specified
level if it is above the upper mark.
1
Oil dipstick
2
Lower level mark
3
Upper level mark
U68T14.book Page 7 Monday, April 1, 2002 4:32 PM
Summary of Contents for F6B
