8-58
0
1
2
3
4
5
6
7
8
9
10
A
2.
While holding the special service tool
3
,
strike the tool to check that the taper
roller bearing outer race is installed prop-
erly. If a high-pitched metallic sound is
produced when the special service tool is
struck, the outer race is installed prop-
erly.
3.
Install a new needle bearing into the
lower case to the specified depth.
TIP:
9
Install a new needle bearing with the manu-
facture identification mark
b
facing upward.
9
When using the driver rod, do not strike the
special service tool in a manner that will
force the stopper
c
out of place.
4.
Install the drive shaft sleeve
8
, original
shim(s)
9
, and a new taper roller bear-
ing outer race
0
.
NOTICE:
When heat-
ing the lower case, heat the entire
installation area evenly. Otherwise,
the paint on the lower case could be
burned.
TIP:
9
Install the drive shaft sleeve with the protru-
sion
c
facing forward.
9
Do not reuse a shim if it is any deformed or
scratched.
5.
While holding the special service tool
3
,
strike the tool to check that the taper
roller bearing outer race is installed prop-
erly. If a high-pitched metallic sound is
produced when the special service tool is
struck, the outer race is installed prop-
erly.
Driver rod LL
3
: 90890-06605
Bearing outer race attachment
4
:
90890-06621
Driver rod SL
5
: 90890-06602
Needle bearing attachment
6
:
90890-06611
Bearing depth plate
7
: 90890-06603
Installation depth
a
:
187.6–188.6 mm (7.39–7.43 in)
3
4
3
4
5
6
7
c
a
6
5
b
F
8
9
0
c
Drive shaft and lower case (FT50C)
Summary of Contents for F50D
