Operation
71
with no binding or excessive free play.
●
Operate the throttle levers several times to
make sure there is no hesitation in their
travel. Operation should be smooth over
the complete range of motion, and each le-
ver should return completely to the idle po-
sition.
EMU40362
Engine shut-off cord (lanyard)
Check the engine shut-off cord and clip for
damage, such as cuts, breaks, and wear.
EMU37042
Engine oil
1. Put the outboard motor in an upright po-
sition (not tilted).
NOTICE:
If the motor
is not level, the oil level indicated on
the dipstick may not be accurate.
[ECM01790]
2. Remove oil dipstick and wipe it clean.
3. Insert the dipstick and remove it again.
Be sure to completely insert the dipstick
into the dipstick guide, otherwise the oil
level measurement will be incorrect.
4. Check the oil level using the dipstick to
be sure the level falls between the upper
and lower marks. Consult your Yamaha
dealer if the oil level is out of specified
level or if it appears milky or dirty.
EMU27153
Engine
●
Check the engine and engine mounting.
●
Look for loose or damaged fasteners.
●
Check the propeller for damage.
●
Check for engine oil leaks.
EMU36492
Flushing device
Check that the flushing device’s garden hose
connector is securely screwed on to the fit-
ting on the bottom cowling.
NOTICE:
If the
garden hose connector is not properly
connected, cooling water can leak out
and the engine can overheat during oper-
ation.
[ECM01801]
1. Clip
2. Engine shut-off cord (lanyard)
ZMU06873
1
2
1. Oil dipstick
1. Oil dipstick
2. Lower level mark
3. Upper level mark
1
ZMU05905
ZMU05918
1
3
2
6AW-9-18.book 71 ページ 2010年3月22日 月曜日 午前11時35分
©
2019 Yamaha Motor Corporation, U.S.A.