Single cable multiswich programmer PC102W
1.
Product description
The PC102W - single cable multiswich programmer (in the text - programmer) is useful instrument while configuring and troubleshooting SAT IF
distribution system built on dSCR multiswitches based on new digital channel stacking components.
The application software “dSCRmaster” for Windows operating system PCs allows simply change parameters of the multiswitch: operating mode
(static or dynamic), frequency plan for static mode, frequency and bandwidth of user bands for dynamic mode, output power level of each user
band carrier and etc.
Service mode of the multiswitch could be switched on for quick finding the problem during installation work. In an internal memory four different
configuration files can be stored (prepared on the PC) and send to the multiswitch by pressing dedicated buttons on the PC102W.
The programmer can feed DC power for the multiswitch using the external AC/DC power adapter and allows parallel connection to a PC over USB
cable. The remote Wi-Fi access allows to modify parameters of dSCR multiswitch from any device (tablet, smartphone, laptop, PC) using web
browser. The PC102W, wirelessly connected to the WiFi access point, can be used for remote control and monitoring of the multiswitch.
The programmer is supplied with an external AC/DC adapter (PS202F). An application SW “dSCRmaster” is available from the Web.
2.
Safety instructions
Installation of the programmer must be done according IEC60728-11 and national safety standards.
Any repairs must be made by qualified personnel.
To avoid the electric shock follow these instructions:
● Do not expose this programmer to moisture or splashing water and make sure no objects filled with liquids, such as vases, are placed
near or on the unit.
● Avoid placing the programmer next to heat sources such as central heating components or in areas of high humidity.
● Keep the programmer away from naked flames.
● If the programmer has been kept in cold conditions for a long time, bringing it into a warm environment may cause condensation, so allow it to
warm up for no less than 2 hours before plugging into the mains.
● Ventilation should not be impeded by covering the programmer, such as newspapers, table-cloths, curtains etc.
●
The programmer
must be fixed with steel screws Ø 3.5-4 mm. The screws are not included in a package.
● Always allow 10 cm of free space from the top, front and bottom of the unit to enable any heat to be dissipated.
3.
External view
Figure 1. External view of the programmer
Vers. 1.01
5 6 7 8
2
1
3
4
9
1
.
DC IN
- DC power voltage input 20V 1-2A from AC/DC adapter.
2
.
RF IN
- RF input from controlled multiswitch, DC power voltage 18V 1A max. to the multiswitch.
3
.
RF OUT
- RF output to receiver, DC pass from receiver to RF input.
4
.
Status LED. Blinks green two times per second with 1/2 duty cycle when Wi-Fi is connected, blinks green two times per second
with 1/10 duty cycle, when no Wi-Fi connection available, blinks green ten times per second during communication with the
multiswitch, glows red after communication error with the multiswitch.
5-8
. Buttons for sending a stored configuration to the multiswitch. Button number corresponds to the stored configuration number.
9
.
Micro USB connector for PC connection.
1
