3-28
VALVE
a
a
VALVE SEAT INSPECTION
1. Remove carbon deposits from the valve
face and valve seat.
2. Apply a small amount of coarse mechan-
ic's blueing dye (Dykem) to the valve
face.
3. Insert the vale into the valve guide and
use a valve lapper to contact the valve
face with the valve seat.
NOTE:
Do not rotate the valve while the valve face is
contacting the valve seat.
4. Measure:
9
Valve face contact width
a
Make sure that the contact width along
the entire valve face is within specifica-
tions.
Out of specification/rough/eccentric
wear
→
Replace.
5. Measure:
9
Valve seat contact width
a
Make sure that the contact width along
the entire valve seat is within specifica-
tions.
Out of specification/rough/eccentric
wear
→
Replace.
ENG
Valve face contact width (intake
and exhaust):
0.7 mm (0.03 in)
Limit: 1.7 mm (0.067 in)
Valve seat contact width (intake
and exhaust) :
0.7 mm (0.03 in)
Limit: 1.7 mm (0.067 in)
7CF7E0-03 05.7.3 15:14 Page 28
