Power On Auto-Pairing
If your phone has previously been paired with one
speaker, please follow these steps for your next use.
Turn on one EX Footwell speaker. The speaker will
announce, “Ready to Connect.”
Turn on the other EX Footwell speaker.
The two speakers will automatically pair to each other
and reconnect to your phone.
Attaching Speaker Onto Your Mounts
1
2
3
3
IMPORTANT: Installation & Waterproofness
Installing the EX Footwell Speaker Mounts
In order to attach the EX Footwell speaker mounts, we
recommend that you have a licensed Yamaha dealer
drill holes into your Yamaha WaveRunner EX personal
watercraft. Doing it yourself could damage your vehicle,
and void the warranty.
Maintaining
Waterproofness
If the cap on the back panel
is not properly closed, the
unit is
NOT
watertight.
To ensure the unit is
watertight & waterproof,
ALWAYS CLOSE THE
CAP PROPERLY
.
To do so, turn the
cap all the way to the
RIGHT
(clockwise).
SAFETY ADVISORY & WARNING:
Read and follow all instructions. Use only as intended.
CAUTION: Do
NOT
open to repair. A qualified technician must carry out repair work.
ATTENTION: Do
NOT
charge while the unit is wet. Towel dry the unit
AND
make sure all
connections are dry
BEFORE
plugging in the charging connector. Failure to do
so may result in electrical damage to the unit and may void the warranty.
PROPOSITION 65
WARNING:
Cancer and Reproductive Harm - www.P65Warnings.ca.gov
WARNING:
EX Footwell speakers have a built-in Lithium battery. The battery must
NOT
be used in or near an open heat source or excessive heat.
WARNING:
Danger of explosion if battery is incorrectly replaced.
ATTENTION: Do
NOT
dispose of in a landfill. Contact Grace Digital at
support.gracedigital.com or a certified recycling agent to
dispose of the unit.
ATTENTION: AC adapter is a device forming a part of the main plug; therefore, an AC
adapter can always be readily disconnected from AC socket-outlet.
SAFETY:
This product has a limited life span of use and should be replaced when it shows obvious
signs of wear.
Do not modify or remove any original component parts of the speaker. Doing so could cause
damage to the unit allowing water to ingress. A unit with water ingress should not be charged
due to potential risk of fire or shock.
Do not attempt to mount the unit except with the approved ECOXGEAR mounts. Doing so
could cause damage to the unit allowing water to ingress. A unit with water ingress should
not be charged due to potential risk of fire or shock.
Please exercise care and good judgment when using your ECOXGEAR speaker. Audio levels
should be appropriate to your environment, comply with all local regulations, and always
ensure that you can hear and be aware of any potential hazards around you.
You should always
1) Use the ECOXGEAR speaker in accordance with any music or noise rules and regulations.
2) Use the proper ECOXGEAR mounts if you intend to mount the unit.
3) Properly seal the ECOXGEAR prior and after each use when in humid or water
environments to avoid water damage to the internal components. Salt water / air is
particularly corrosive. Always make sure that the gaskets are sealed when in salt water
environment and the unit properly rinsed off after use.
4) Properly clean the ECOXGEAR and ensure the gaskets have no sand, dirt, or water on
them prior to storage or removing the back cover.
5) Store your unit with all caps properly sealed to avoid long term internal moisture damage
inside
your
unit.
6) Completely dry and clean your ECOXGEAR prior to attempting to charge the unit.
7) Return the ECOXGEAR to Grace Digital if you suspect water ingress into the unit or if the
unit has experienced a severe impact that may have affected the integrity of the unit to
take
on
water.
