Types of Input Signals
77
T
ypes of Input Signals
Switching Input Modes
TV
CH
CINEMA
CH
POWER
POWER
AUDIO
/DTS
SELECT
NIGHT
SW
TV CH
TV INPUT
SLEEP
PRESET
PRESET
A B C D E
CENTER
SURR
SHIFT
STEREO
MATRIX 6.1
A-B
REPEAT
ANGLE
SUBTITLE
DVR-S120 WB56650
ON SCREEN
MENU
TEST
RETURN
STATUS
TV VOL
VOLUME
MUTE
AMP
DVD/CD
VCR
VIDEO
TUNER
MOVIE
MUSIC
SPORTS
GAME
SET MENU
ENTER
• It is possible to switch Input mode even if you press INPUT on CinemaStation for more than one second.
• When Input mode is set to AUTO and a Dolby Digital or DTS signal is input, the most suitable decoder is automatically
selected.
• The following happens when set to Input mode and DTS is played:
— CinemaStation detects the DTS signal and automatically switch to DTS mode (
t
indicator lights up). Once DTS audio
finishes playback, the
t
indicator may blink, and while it blinks only DTS audio can be played back. Immediately after
DTS audio finishes playback, if you want to play normal PCM audio, reset the Input mode to AUTO.
— If the DTS signal is interrupted when you perform Search or Skip, the
t
indicator may blink. If this condition continues
for over 30 seconds, the Input mode automatically changes from DTS to normal digital (PCM) and the
t
goes out.
• Using “* Input Mode” in the SET MENU you can set whether to use the Input mode specified previously when CinemaStation
was turned on or return to AUTO.
• It is not possible to select ANLG with the DVD/CD Input Selection button.
• You cannot switch input modes when the input jack you select with the Input Selection button can only input an analog input
signal.
• To play back DTS, set the Input mode to AUTO or DTS. Do not set it to ANLG. If you do, audio may not output or you may
hear noise.
You can playback most sources without a problem with
the AUTO setting (factory default setting). Then depending
on your needs, you can select the priority level for digital
and analog input signals, and specify formats such as
DTS.
Press the Input Selection button for current input
source until the desired input mode appears in the
CinemaStation Display.
AUTO
:
Input signal can be selected in the order below.
1) Digital signal
2) Analog signal
DTS
:
Only DTS can be played.
ANLG
:
Only analog signal can be played.
Learning about input modes, jacks and Input Selection
buttons
CinemaStation can receive signals from the VIDEO (analog),
VCR (analog) and OPTICAL (digital) jacks of equipment that
is connected to it. You can assign a VIDEO or VCR input name
to the OPTICAL IN jack. This will allow you to use the VIDEO
button or VCR button to input a device connected to the
OPTICAL IN jack (VIDEO is assigned in the default setting.)
Normally, an analog signal is input to the VIDEO or VCR IN
jack, and a digital signal is input to the OPTICAL IN jack.
However, by setting the input mode to AUTO the input will be
automatically detected and you can then playback audio from
the device you want by simply pressing an Input Selection
button.
Advice
Note
Input
Selection
buttons
English
