27
■
Wah Pedal Settings
These settings are available when the Wah Pedal
function (“
UUH
”) is selected as the controller in the
External Control settings.
Press the [UTILITY] button then set the amp select
switch to CRUNCH1 (“
UUH
” will appear on the dis-
play).
●
Set the Low Frequency of the Wah Pedal
Sets the low frequency in the wah pedal’s frequency
range.
Press the [COMP] button and use the [UP]/[DOWN]
buttons to set the frequency (
150
-
500
:Hz).
●
Set the High Frequency of the Wah Pedal
Sets the high frequency in the wah pedal’s frequency
range.
Press the [CHORUS] button and use the [UP]/
[DOWN] buttons to set the frequency (
1 . 5 0
-
5.00
:kHz).
●
Set the Wah Pedal “Q”
Sets the frequency curve of the wah pedal.
Press the [FLANGER] button and use the [UP]/
[DOWN] buttons to select a curve (
1.00
-
5.00
).
■
The Speaker Simulator
Press the [UTILITY] button then set the amp select
switch to CRUNCH2. The current setting will appear
on the display.
Use the [UP]/[DOWN] buttons to select a speaker
simulator mode.
•
GLb
: The speaker simulator is always ON.
•
PrG
: The speaker simulator is switched ON/
OFF according to the patch setting.
•
oFF
: The speaker simulator is always OFF
Utility Mode
■
Preamp Circuit ON/OFF Settings
When the DG-Stomp’s preamp circuit is not used, it
is possible to use the DG-Stomp as an effector or a
MIDI foot controller.
Press the [UTILITY] button then set the amp select
switch to CLEAN1.
Use the [UP]/[DOWN] buttons to set the preamp cir-
cuit ON/OFF.
•
on
: The preamp circuit is active (in use)
•
oFF
: The preamp circuit is inactive (not in use)
Summary of Contents for DG-Stomp
Page 1: ...Owner s Manual ...
Page 32: ...Printed in Taiwan V573390 ...
