GEN
INFO
E
Keep Work Area Clean
Properly ventilate your work area.
Keep the shop bench and floor clean and dry.
Cover all parts and part openings when they
are not being worked on, to prevent foreign
materials from entering and damaging the
drive unit.
Cleaning and protection of machined sur-
faces and friction areas are part of the repair
procedure; this is considered standard shop
practice.
Operate Stern Drive Safely
Remove the propeller. (Refer to “PROPELLER
SHAFT AND NUT INSPECTION” section (P3-
31).)
DO NOT operate engine without cooling
water supplied to the water inlet ports on the
drive unit.
SAFETY PRECAUTIONS / PRE-DELIVERY IN-
SPECTION
2
1
3
PRE-DELIVERY INSPECTION
Perform the following inspections to prepare
the outdrive for delivery to the customer.
Check Engine Alignment
¡
Use an engine alignment tool to check
engine alignment. Make any adjust-
ments as necessary. (Refer to “ENGINE
ALIGNMENT” section (P3-29).)
¡
Make sure all engine mounting hardware
is tight.
Inspect Drive Belts
Check the tension of the alternator belts.
Check Gear Oil
Make sure break-in oil is at the proper level.
Inspect Outdrive Exterior
¡
Touch-up any painted surfaces with
matching paint.
¡
Replace any parts damaged in shipping.
Check Power Trim System
¡
Check the oil level of the trim pump res-
ervoir
1
.
¡
Make sure all wires
2
and hydraulic lines
3
are connected properly.
¡
Use the trim switch to check the trim op-
e r a t i o n . M a k e s u r e l i n e s a n d
wireharnesses do not bind and are not
interfered with when the outdrive is
moved up, down, right or left.
1-3
Summary of Contents for DE-DHT
Page 1: ...070030 E STERNDRIVE SERVICEMANUAL DE DHT 6U5 28197 ZJ 11 ...
Page 6: ......
Page 8: ......