RIVAGE PM7 System Setup Guide
29
C
Vent
The digital mixing console is equipped with cooling
fans. These vents let warm air out from the unit.
Please make sure that you do not block the vents with
any object.
D
AC IN connectors
Use these sockets to connect the supplied power
cords. First connect the AC power cords to this unit,
and then insert the power cord plugs into AC outlets.
Insert the cable plugs all the way until they lock in
place securely. The supplied AC power cords feature a
V-lock mechanism via a latch, which prevents the
power cords from disconnecting accidentally.
Caution
Be sure to turn off the power to the unit before connecting
or disconnecting the power cords.
To disconnect each power
cord, remove it while
pressing the latch on the
plug.
E
I/
P
(Power switches)
Toggle between power on (
I
) and off (
P
).
F
HY card slots
Enable you to install optional HY cards and connect
to an I/O rack, such as RPio622, to expand I/O ports.
●
Shutting down the power to the unit
Before you turn off the power to the digital mixing
console, Yamaha recommends that you store the current
status to scene memory.
If you change the connection status of the components
after the power is turned off, some settings, such as
patching, may be altered when you turn the power on
again. For more information on storing a scene, please
refer to the Operation Manual.
NOTE
If you turn off the power to the digital mixing console without
following the shutdown procedure, data inside the built-in
storage may be damaged. Be sure to perform the shutdown
procedure to turn off the power to the digital mixing console.
1.
Press the [SYSTEM] key (
) for
two seconds or longer.
A message will ask you to confirm the shutdown
operation.
2.
To turn the power off, press the OK button. To
cancel shutdown, press the CANCEL button.
3.
Wait until the LEDs on the panel turn off and
the touch screens go dark.
4.
Turn off both power switches A and B on the
rear panel.
Caution
If you plan to turn on the power to the control surface again, wait
at least five seconds before switching the power on. Otherwise,
the unit may malfunction.
Even when the power switches are turned off, a small amount of
current still flows through the unit. If you plan not to use the unit
for a long period of time, remove the power cords from the AC
outlets.
Summary of Contents for CSD-R7
Page 1: ...DIGITAL MIXING CONSOLE CSD R7 System Setup Guide EN ...
Page 55: ...RIVAGE PM7 System Setup Guide 55 MEMO ...
Page 56: ......
