18
En
Troubleshooting
Radio reception
Problem
Cause
Solution
Refer to
The preset tuning
function does not
work.
The preset station settings may have been
erased.
Preset radio stations again.
P. 12
The preset station
settings have been
cleared.
The power to this unit may be lost more
than a week.
Make sure the power cable is plugged into
outlet firmly, and then preset the stations
again.
P. 5, 12
The auto tuning
function does not
work.
The antenna may be connected
improperly.
Make sure the antenna is connected properly.
P. 5
The radio station you selected may be far
away from your area or radio wave
reception is weak in your area.
Try manual tuning to increase the signal
quality.
P. 12
(FM) Too much
noise is generated
during stereo
broadcast.
The FM antenna may be connected
improperly.
Make sure the FM antenna is connected
properly.
P. 5
The radio station you selected may be far
away from your area or radio wave
reception is weak in your area.
Try manual tuning to increase the signal
quality or use a commercially available
multi-channel outdoor antenna.
P. 5, 12
Switch the reception mode of this unit to
monaural.
P. 12
(FM) Even with an
outdoor antenna,
radio wave
reception is weak
(audio is distorted).
Multipath reflection or other radio
interferences may occur.
Change the height, direction, or placement
of the antenna.
—
(AM) Too much
noise is generated.
The noises may be generated from
atmospheric electricity, lightening,
fluorescent lights, motors, or thermostat
electric devices.
Connect an outdoor antenna and establish
better grounding to decrease noises.
However, it is difficult to eliminate these
types of noises.
P. 5
If too much noise is generated especially
in the evening, this unit may be placed
close to a TV.
Place this unit further away from a TV.
—
(DAB) Cannot tune
into any DAB
stations.
There is no DAB coverage in your area.
—
(DAB) The service
reception is weak.
The positioning of the indoor DAB
antenna and/or the unit is not optimal for
DAB reception.
Display the signal strength and find the best
position for the DAB antenna and this unit.
P. 14
Remote control
Problem
Cause
Solution
Refer to
The remote control
does not work for
operating this unit.
The remote control may be operated
outside the remote control operation
range.
Use the remote control within the operation
range.
P. 3
The remote control sensor on this unit
may be exposed to direct sunlight or
lighting (inverted fluorescent lamps).
Change the lighting or the orientation of this
unit.
—
The batteries may be worn out.
Replace the batteries with new ones.
P. 5
