Basic operation of this unit
6
En
y
The circled numbers and alphabets correspond to the ones on the attached sheet.
Press
1
STANDBY/ON
(or
A
STANDBY/ON
) to
turn on this unit.
Press it again to set this unit to the standby mode.
y
• You can select whether to display the clock (ECO OFF mode)
or not (ECO ON mode) when this unit is in the standby mode.
Press and hold
I
TIME MODE
during standby mode until
“ECO OFF” or “ECO ON” appears.
• To charge your iPod while this unit is in the standby mode,
select “ECO OFF”.
• The memory back-up circuit prevents the clock setting from
being lost even if this unit is in the standby mode. However, the
clock setting will be lost if the power cable is disconnected from
the AC wall outlet or if the power supply is cut off for more than
four minutes.
• In the standby mode, this unit consumes a small amount of
power.
Press one of the
input selector buttons
(
2
)
repeatedly (or press
N
INPUT
) to select the
input source from CD, iPod, TUNER (FM/AM/
DAB), and AUX.
• Press
D
BAND
(or
E
BAND
) to select FM, AM, or
DAB.
• For details on CD, iPod, and tuner operations, refer to
pages 8, 10, 12, and 14.
• When you select AUX, this unit outputs sound played
back on the component which is connected to the AUX
IN jacks. While AUX is selected as the input source,
this unit does not output signals at the AUX OUT
jacks.
Press
K
(or rotate
O
VOLUME
clockwise) to increase the volume level and
press
K
VOLUME –
(or rotate it counter-
clockwise) to decrease it.
■
Muting the sound
Press
L
MUTE.
To restore audio output to the previous volume level, press
it again or press
K
/–
.
1
Press
I
FUNCTION
(or
K
FUNCTION
).
2
Press
0
/
repeatedly (or rotate the
multi jog dial
(
J
)) to select the setting from
“Bass” (low frequency), “Treble” (high
frequency), and “Balance” (speaker balance),
and then press
0
ENTER
(or push the
multi
jog dial
(
J
)).
3
Press
0
/
repeatedly (or rotate the
multi jog dial
(
J
)) to adjust the setting and
then press
0
ENTER
(or push the
multi jog dial
(
J
)).
The setting ranges are as follows:
Bass ..................... –10 dB to +10 dB
Treble................... –10 dB to +10 dB
Balance ................ L +6 to R +6
These settings have no effect on the audio signals output at the
AUX OUT jacks and the DIGITAL OPTICAL OUT jack.
Connect the headphone plug to the
H
PHONES
jack.
y
While headphones are connected, the sound from the speakers
and subwoofer is cut off.
Press
4
DIMMER
repeatedly.
You can select the brightness level from bright, mid dim,
and dim.
Basic operation of this unit
Turning on the power
Selecting an input source
Adjusting the volume level
Adjusting sounds
Note
Listening through the headphones
Changing the brightness of the
display
