CVP-405/403/401 Owner’s Manual
207
Appendix
6
Installing E.
7
Connect the pedal cord.
8
Set the voltage selector and connect the power
cord.
Voltage Selector
Before connecting the AC power cord, check the setting of the volt-
age selector which is provided in some areas. To set the selector
for 110V, 127V, 220V or 240V main voltages, use a “minus” screw-
driver to rotate the selector dial so that the correct voltage for your
region appears next to the pointer on the panel. The voltage selec-
tor is set at 240V when the unit is initially shipped.
After the proper voltage has been selected, connect the AC
power cord to the AC INLET and an AC wall outlet. A plug adap-
tor may be also provided in some areas to match the pin config-
uration of the AC wall outlets in your area.
WARNING
An improper voltage setting can cause serious damage to
the instrument or result in improper operation.
9
Set the adjuster.
Rotate the adjuster until it
comes in firm contact with
the floor surface.
■
After completing the assembly, please check
the following.
D
E
E
D
1
Remove the plastic
cover from D.
2
Untie and straighten
out the bundled
cord attached to the
bottom of E.
3
Pass the pedal
cord between E
and D.
4
Make sure that E lays flat, with no gap between
itself and the floor, then affix the E using two
screws.
1
Insert the
pedal cord
plug into the
pedal connec-
tor.
Insert the plug
with the
arrow-printed side facing front
(toward the keyboard side).
If the plug will not go in easily,
do not force it. Double-check
the orientation of the plug,
then try again.
2
Align the pedal cord into
the groove on D, and install
the plastic cover onto the
groove. Be careful not to
insert the cover’s
attachment strip between
the groove wall and the leg.
Correct
Incorrect
240
127
110
220
(the bottom of the right side
as seen from the front)
• Are there any parts left over?
→
Review the assembly procedure and correct any
errors.
• Is the instrument clear of doors and other movable
fixtures?
→
Move the instrument to an appropriate location.
• Does the instrument make a rattling noise when
you shake it?
→
Tighten all screws.
• Does the pedal box rattle or give way when you
step on the pedals?
→
Turn the adjuster so that it is set firmly against the
floor.
• Are the pedal and power cords inserted securely
into the sockets?
→
Check the connection.
• If the main unit creaks or is otherwise unsteady
when you play on the keyboard, refer to the assem-
bly diagrams and retighten all screws.
When moving the instrument after assembly, always
hold the bottom of the main unit.
CAUTION
Do not hold the key cover or top portion. Improper handling
can result in damage to the instrument or personal injury.
Top portion
Key cover
Do not hold here.
Hold here.
Do not
hold here.