6. After about 30 seconds, the tray opens automatically.
Remove the firmware CD.
*
At this time, do not turn off the power as writing
of the firmware is going on in this unit.
*
Writing takes about 1 minute 30 seconds.
7. After writing is over, the system is restarted
automatically.
8. After “NO DISC” is displayed, set the “STANDBY/
ON, OFF” (U, K, A, B, G, L, V, S models) / “ ”
(Power) (T model) switch to the “OFF” position.
9. Start up the self-diagnostic function and check
that the firmware version is the same as written
one. (For details, refer to “Confirmation of firmware
version and checksum”)
6. 約 30 秒後、自動的にトレイが開きます。
ファームウェア CD を取り出します。
※ このとき、本機はファームウェアの書き込み
を継続しています。電源は切らないでくださ
い。
※ 書き込み時間は、約 1 分 30 秒ほどかかります。
7. 書き込み終了後、自動的に再起動します。
8. “NO DISC” と表示された後、“STANDBY/ON、OFF”
(電源)スイッチを “OFF” にします。
9. ダイアグを起動し、ファームウェアバージョンが
書き込まれたものと同じであることをチェックし
ます。(詳細は “ファームウェアのバージョンと
チェックサムの確認” を参照してください。)
5. Press the “
” (PLAY) key, and then writing of the
firmware is started. (Fig. 2)
5. “
”(PLAY)キーを押し、書き込みを開始します。
(Fig. 2)
Fig. 2
FL display
FL ディスプレイ
Front view
“STANDBY/ON, OFF” switch
(U, K, A, B, G, L, V, S models)
“ ” (Power) switch
(T model)
STANDBY/ON、OFF (電源)
スイッチ
(U, K, A, B, G, L, V, S, J models)
(T model)
“ ” (PLAY) key
(PLAY)キー
30
CD-S2100
CD-S21
0
0
Summary of Contents for CD-S2100
