Operation an
d
important ri
d
in
g
points
6-1
6
EAU15952
Read the Owner’s Manual carefully to
become familiar with all controls. If
there is a control or function you do not
understand, ask your Yamaha dealer.
WARNING
EWA10272
Failure to familiarize yourself with
the controls can lea
d
to loss of con-
trol, which coul
d
cause an acci
d
ent
or injury.
EAU48712
TIP
This model is equipped with:
a lean angle sensor to stop the en-
gine in case of a turnover. In this
case, the display will indicate error
code 30, but this is not a malfunc-
tion. Turn the key to “OFF” and
then to “ON” to clear the error
code. Failing to do so will prevent
the engine from starting even
though the engine will crank when
pushing the start switch.
an engine auto-stop system. The
engine stops automatically if left
idling for 20 minutes. If the engine
stops, simply push the start
switch to restart the engine.
EAU47106
Startin
g
the en
g
ine
In order for the ignition circuit cut-off
system to enable starting, one of the
following conditions must be met:
The transmission is in the neutral
position.
The transmission is in gear with
the clutch lever pulled and the
sidestand up.
See page 4-15 for more informa-
tion.
1. Turn the key to “ON” and make
sure that the engine stop switch is
set to “
”.
The following warning lights
should come on for a few sec-
onds, then go off.
Oil level warning light
Fuel level warning light
Engine trouble warning light
NOTICE
ECA15486
If a warnin
g
li
g
ht
d
oes not come on
initially when the main switch is
turne
d
on, or if a warnin
g
li
g
ht re-
mains on, see pa
g
e 4-1 for the corre-
spon
d
in
g
warnin
g
li
g
ht circuit
check.
UBP612E0.book Page 1 Tuesday, July 3, 2018 4:41 PM
