Yamaha BOLT, Owner'S Manual

Page: 33 / 98

Instrument an d control functions
4-14
4
Bolt R-Spec
WARNING
EWA10232
These shock a b sor b er assem b lies
contain hi g hly pressurize d nitro g en
g as. Rea d an d un d erstan d the fol-
lowin g information b efore han d lin g
the shock a b sor b er assem b lies.

Do not tamper with or attempt
to open the cylin
d er assem b lies.

Do not su b ject the shock a b -
sor b er assem b lies to an open
flame or other hi g h heat source.
This may cause the unit to ex-
plo
d e d ue to excessive g as
pressure.

Do not d eform or d ama g e the
cylin d ers in any way. Cylin d er
d ama g e will result in poor
d ampin g performance.

Do not d ispose of a d ama g e d or
worn-out shock a b sor b er as-
sem b ly yourself. Take the shock
a b sor b er assem b ly to a Yamaha
d ealer for any service.
EAU15306
Si d estan d
The sidestand is located on the left
side of the frame. Raise the sidestand
or lower it with your foot while holding
the vehicle upright.
TIP
The built-in sidestand switch is part of
the ignition circuit cut-off system,
which cuts the ignition in certain situa-
tions. (See the following section for an
explanation of the ignition circuit cut-
off system.)
WARNING
EWA10242
The vehicle must not b e ri dd en with
the si d estan d d own, or if the si d e-
stan d cannot b e properly move d up
(or d oes not stay up), otherwise the
si d estan d coul d contact the g roun d
an d d istract the operator, resultin g
in a possi b le loss of control.
Yamaha’s i g nition circuit cut-off
system has b een d esi g ne d to assist
the operator in fulfillin g the respon-
si b ility of raisin g the si d estan d b e-
fore startin g off. Therefore, check
1. Spring preload adjusting ring
2. Stopper
Sprin g preloa d settin g :
Minimum (soft):
1
Standard:
2
Maximum (hard):
5
1
2
3
4
5
1
(a)
(b)
2
UBP612E0.book Page 14 Tuesday, July 3, 2018 4:41 PM