5-4
JUMP STARTING
➀
Negative (–) jumper cable
➁
Positive (+) jumper cable
If the boat battery runs down, the
engines can be started in an emer-
gency using a 12-volt battery and
jumper cables.
SEVERE INJURY OR DEATH MAY
RESULT IF YOU IGNORE ANY OF
THE FOLLOWING:
●
If blower will not operate, venti-
late engine compartment by
opening engine compartment
hatch for several minutes before
attempting a jump start.
●
Do not connect the negative (–)
jumper cable to the negative (–)
terminal of the dead battery.
Sparks could ignite battery or
fuel vapors, which could cause
an explosion.
To connect the jumper cables:
1) Connect the positive (+) terminal of
the dead battery to the positive ter-
minal (+)of the booster battery with
the positive jumper cable.
2) Connect one end of the negative (–)
jumper cable to the negative (–) ter-
minal of the booster battery.
3) Connect the other end of the nega-
tive (–) cable to an engine hanger
on either side of the engine oil tank.
Be sure all connections are secure
and correct before attempting to start
the engine. Any wrong connection
may damage the electrical system.
4) Start the engine, then disconnect
the cables by reversing the above
steps.
Do not turn the starter motor for
more than 5 seconds. If the engine
does not start in 5 seconds, release
the starter switch and try again after
15 seconds. Continuous cranking for
more than 5 seconds will discharge
the battery and the engine will not
start. The starter motor may also be
damaged if it is engaged continuous-
ly for more than five seconds.
5
T
ROUBLESHOOTING
& S
PECIAL
P
ROCEDURES
CAUTION:
CAUTION:
WARNING
ENGINE
HANGER
11 12 13 14 15 16 17 18 19 20
21 22 23 24 25 26 27 28 29 30
31 32 33 34 35 36 37 38 39 40
41 42 43 44 45 46 47 48 49 50
51 52 53 54 55 56 57 58 59 60
1 2 3 4 5 6 7 8 9 10
11 12 13 14 15 16 17 18 19 20
21 22 23 24 25 26 27 28 29 30
31 32 33 34 35 36 37 38 39 40
41 42 43 44 45 46 47 48 49 50
51 52 53 54 55 56 57 58 59 60
1 2 3 4 5 6 7 8 9 10
Summary of Contents for AR230 High output
Page 1: ......
