Periodic maintenance and adjustment
63
3.
Rotate the secondary sliding sheave
clockwise and push it so that it separates
from the secondary fixed sheave.
4.
Pull the V-belt up over the secondary
fixed sheave.
5.
Remove the V-belt from the secondary
sheave assembly and primary sheave
assembly.
6.
Temporarily install the new V-belt on the
secondary sheave assembly only, and
then measure the V-belt position. Do not
force the V-belt between the sheaves; the
secondary sliding and fixed sheaves
must touch each other.
7.
If the V-belt position is incorrect, adjust it
by removing or adding a spacer on each
V-belt position adjusting bolt.
1. Secondary sliding sheave
2. Secondary fixed sheave
1. V-belt
1. Edge of the secondary sheave assembly
2. Standard V-belt position
Standard V-belt position:
From 1.5 mm (0.06 in) above the
edge of the secondary sheave as-
sembly to 0.5 mm (0.02 in) below the
edge
2
1
U8HG10E0.book Page 63 Tuesday, May 18, 2010 5:39 PM
