Periodic maintenance and adjustment
54
9.
Fit the weatherstrip on the headlight unit
into the recess in the top of the air filter
case cover.
10. Install the headlight unit bolts, and then
tighten them to the specified torque.
11. Install the top cover, the left and right side
covers, and the shroud.
ESU11863
Checking the throttle override
system (T.O.R.S.)
WARNING
EWS00352
When checking the T.O.R.S., take precau-
tions to avoid snowmobile movement
which could cause an accident:
●
Make sure that the throttle lever moves
smoothly with the engine off before
checking the T.O.R.S.
●
Make sure that the parking brake is ap-
plied.
●
Do not rev the engine to the point that
the clutch engages.
Check the T.O.R.S. for proper operation.
1.
Start the engine.
TIP
Refer to the “Starting the engine” section on
page 37.
2.
Hold the pivot point of the throttle lever
away from the throttle switch by putting
your thumb (above) and forefinger (be-
low) between the throttle lever pivot and
the engine stop switch housing.
While holding the pivot point as described
above, squeeze the throttle lever gradu-
ally.
1. Weatherstrip
Headlight unit bolt tightening torque:
3.0 Nm (0.30 m·kgf, 2.2 ft·lbf)
1
U8HG10E0.book Page 54 Tuesday, May 18, 2010 5:39 PM
