PERIODIC MAINTENANCE AND ADJUSTMENT
7-11
7
EWAU0030
WARNING
_
The muffler and muffler protector
become very hot during use. To
avoid possible burns, let the muffler
and protector cool before removing
the oil filler cap.
_
TIP
_
The engine oil should be between the
minimum and maximum level marks.
_
4. If the engine oil is at or below the
minimum level mark, add suffi-
cient oil of the recommended type
to raise it to the correct level.
5. Insert the dipstick into the oil filler
hole, and then tighten the oil filler
cap.
To change the engine oil and clean
the oil strainer
1. Start the engine, warm it up for
several minutes, and then turn it
off.
2. Place an oil pan under the engine
to collect the used oil.
3. Remove the engine oil filler cap
and drain bolt B to drain the oil
from the crankcase.
NOTICE:
When removing the engine oil
drain bolt, the O-ring, compres-
sion spring, and oil strainer will
fall out. Take care not to lose
these parts.
[ECA11001]
1. Engine oil filler cap
1
ZAUU0934
1. Dipstick
2. Maximum level mark
3. Minimum level mark
1
2
3
ZAUU0935
1. Engine oil drain bolt A
2. Engine oil drain bolt B
1
2
ZAUU0947
1PNF8199E0.book Page 11 Friday, August 24, 2012 2:00 PM
