–12–
N Route the wireharness through the guide.
O Place the speed sensor lead between the ribs of
the air filter case.
P Fasten the lean angle cut-off switch lead to the stay
(2 locations). Face the end of the band downward.
Q Hang the wireharness and seat lock cable on the
wire holder.
R Fasten the battery negative lead and the starter
motor lead to the frame with a plastic clamp.
S Route the battery negative lead and the fuse box
lead from the box opening to the bottom of the
cross pipe.
T Pass the black seat lock cable beneath the battery
negative lead and starter motor lead and out to the
inside of the frame.
H Install the box light to the box 1.
I Fasten the auto choke leads (left and right) and
throttle position sensor lead to the frame with a
clamp.
Leave some slack in the lead wires so that when
the vacuum hose is install it does not press against
them.
J Fasten the auto choke leads (left and right) to the
frame with a plastic clamp.
K Pass the auto choke lead (right side) and throttle
position sensor lead by the front bottom side of the
vacuum hose.
L Route the thermo switch lead through the guide.
M Insert the air vent hose through the hole on the left
side of the frame bracket.
Align the white paint mark with the end face of hole.
CABLE ROUTING
SPEC
