– 32 –
•
The ignition cut switch function can be used by combining the harness and kit ECU.
To use the STD switch (left side) to function as the ignition cut switch, connect the wire
sub-lead that was packaged with this set to the terminal that is normally connected to the
left side horn. (See diagram 4.) If you remove the resistor assy. at the tail side, the
ignition cut switch may malfunction in wet weather. (See diagram 5.)
NOTICE
Do not bend the resistor assembly. It will cease to function if it is bent.
Install the switch to the 2-pin black coupler underneath the fuel tank. Turning the switch
ON cuts the ignition.
NOTICE
Do not connect the coupler for resistor (black, 2-prong) and the coupler for power
(white, 2-prong). Connecting them may cause a malfunction. (See diagram 6.)
1
2
(Diagram 4)
(Diagram 5)
6
5
Coupler for resistor
Coupler for power
(Diagram 6)
Summary of Contents for 2010 YZF-R6
