SRM-420ES, SRM-420TES
T410S, B410S
T410TS, B410TS
20
IGNITION SYSTEM
20
3-5 Replacing ignition switch (continued)
13. Install throttle latch (D), hooking torsion spring end (f2) as shown. Install throttle trigger (C) with tor-
sion spring (E) as shown. Connect end (g) of throttle cable (G) to trigger (C) as shown.
14. Install throttle cable (G) and corrugated tube (J)
to the handle grip half as shown.
NOTE:
Set grooves of corrugated tube (J) on ribs
(M) of the handle grip half (Fig.1).
NOTE:
Make sure throttle cable (G) is passing
inside of hand grip boss (L) and install the hand
grip groove surely as shown.
15. Put together both grip halves.
16. Reinstall right-hand grip on handle.
17. Route cable (N) on handle support (P) and
secure with clip (Q) .
NOTE:
Make sure cable (N) routes through ribs of
handle support as shown.
18. Reinstall cable guide. Connect throttle cable
to carburetor. Connect primary lead coupler and
ground lead coupler.
E
Fig.1
C
J
D
G
M
g
L
f2
N
P
Q
