This "self-discharge" is due to a chemical reaction; therefore,
that chemical reaction can be accelerated by heat resulting
in more rapid "self-discharge." The rate of discharge can
amount to an average of about 0.001 point drop in specific
gravity per day.
The following procedure can be followed when placing a bat-
tery in storage or when not in operation for more than 30
days.
1.
Give an equalizing charge prior to placing new batteries in
storage. Used batteries are to be fully charged, then allowed
to balance for approximately three more hours.
2.
Neutralize and clean the battery. Clean with a solution of
100 grams (3.5 oz) of sodium bicarbonate (baking soda) per
1 liter (0.25 gal) of water.
3.
Store in a cool, dry location.
4.
Check each cell in the battery at least once every 30 days
and boost charge when specific gravity falls below 1.240 Hg.
5.
Protect batteries from ambient contamination.
If a greasy film forms on the top of a battery, this is acid and
must be neutralized with the solution described above.
Putting a Stored Lift Truck Back Into Service
1.
Remove all tape, covers, and preservation materials.
2.
Check the lift truck for damage and missing components.
Repair damage and/or replace missing components.
NOTE:
If the lift truck has been stored longer than one year,
all lubricants and fluids must be drained and replaced. See
the
Periodic Maintenance
section of your service manual
for the procedures.
3.
Clean the battery cables and terminals. Check the battery
voltage. If the voltage is not correct, charge battery. Connect
battery cables to battery.
4.
When a lift truck is to be put into service after storage, it
must be given the 250-hour inspection shown in the
Recom-
mended Schedule of Maintenance
.
How to Move a Lift Truck on a Transport
WARNING
Stay a safe distance from the edge of docks, ramps, plat-
forms, and other similar working surfaces. Watch the
“tail swing.” Remember when traveling in the forward
direction and the steering wheel is turned to move the
Maintenance
197
Summary of Contents for Veracitor GCC040VX
Page 81: ...Figure 12 Seat Adjustment Full Suspension Operating Procedures 79...
Page 113: ...Figure 17 Kubota 2 5L LPG Engine Maintenance and Lubrication Points Maintenance Schedule 111...
Page 169: ...Figure 37 LPG Tank and Bracket Maintenance 167...
Page 203: ...Spacer 5 15 4 15 2 15 1 15 11 14...
