Further siren programming
The siren can be configured to your personal
requirements by the use of jumpers.
Jumper positions
J7 on = jamming detection ‘off’;
off = jamming detection ‘on’
J6 on = normal, J6 off = clear memory
J5 on = stand alone operation;
off = slave operation, not used in this
system
J3 on, J4 on = 3 minute siren ‘on’ period
J3 off, J4 on = 5 minute siren ‘on’ period
J3 on, J4 off = 10 minute siren ‘on’ period
J3 off, J4 off = 1 second siren ‘on’ test
period
J2 on = LEDs ‘on’ during siren period;
off = LEDs remain ‘on’ (after an alarm)
until system is disarmed
J1 on = normal; off = learn-in mode
• Jumper 5 must be left in the ‘on’ position.
• J6 must be left ‘on’ in normal service
otherwise the siren will lose its learn-in
memory when the batteries are replaced.
• With J7 ‘off’, jamming by radio interference is
detected when continuously present for more
than 30 seconds and activates the siren only
when armed.
• If jumper 3 and jumper 4 are removed during
the learning-in process, the siren will sound for
1 second if accidentally activated and is useful
for testing. Ensure they are replaced before
replacing the covers.
6
Replace the battery and electronics
compartment covers, ensuring the gasket
between the electronics compartment and
cover is correctly located and the wires placed
in their slots to ensure a good seal from the
environment.
9
J1
J2
J3
J4
J5
J6
J7
Jamming detection
Clear memory (leave ‘on’)
Standalone mode (leave ‘on’)
Siren activation time
Siren activation time
Learning-in mode (leave ‘on’)
Strobe activation mode
Tamper alarm
If the siren detects a tamper condition it will
activate the siren for the programmed period. If
the tamper condition persists the siren will sound
a series of five pips either every time the system
is armed or when the tamper is enabled, to
indicate a fault.
Previous alarm warning
If there has been an alarm when you were
away the siren will sound and flash for 3 seconds
when being disarmed.
Warning
If the siren is activated for 3 seconds
when you disarm your system there could be an
intruder still in your premises.
Strobe LED visibility
The strobe LEDs are intended to work together
with the siren to identify the alarm source.
The strobe is not designed to be viewed from
directly underneath or from the sides. It is
designed to be clearly visible from 10 to 50
metres in normal daylight conditions, away from
direct sunlight.
Radio jamming
This unit is equipped with the latest type of
radio receiver using AM radio technology. If the
system is armed, any criminal attempt to prevent
(or jam) the detector transmissions will be picked
up as interference and will trigger an alarm.
If the alarm is frequently triggered by
interference there may be high levels of unusual
radio signals in your area. Some kinds of
electronic equipment can generate this kind of
radio interference.
In the unlikely event of you experiencing
problems with interference, it is recommended
that you switch jamming detection off.
Please telephone our helpline if you require any
further assistance.
www.ukpanels.com