14
Adding accessories
To provide additional protection you can add extra door/window contacts, PIRs, keyfob
remote controls, keypad remote controls, help buttons and smoke detectors. These are
available separately from your local stockist.
Putting the system in and out of learn
mode
Put the system into learn mode and disable the
system tamper using the keypad as follows.
1
Enter your PIN code, then press TEST. The ‘Tx’
LED will flash showing the keypad is in program
mode.
2
Disable tamper by pressing TEST then 2. The
keypad will beep and the siren confirm.
3
Enter learn mode by pressing TEST then 4. The
keypad will beep and the siren confirm. The
PIRs and Door/window contacts can now be
learnt into the system.
4
Learn in the appropriate device as described.
5
Exit learn mode by pressing TEST then 5, the
keypad will beep and the siren confirm.
6
Enable system tamper by pressing TEST then 3.
The keypad will beep and the siren confiirm.
7
Exit programming by pressing OFF twice.
• When learning in accessories that are not
tamper protected (such as the helpwatch) it is
not necessary to disable the system tamper,
therefore steps 2 & 6 can be ignored.
• If accidentally left in learn mode, the system
will revert to normal in about 3 minutes.
• If accidentally left with tamper dissabled the
system will revert to normal in about 1 hour.
Remote keyfob accessory
The keyfob accessory allows you to operate the
system from outside the premises. Along with
panic attack feature, the keyfob also allows you to
put the system in and out of learn mode and
disable/enable the system tamper.
• Please note that the Home feature is not used
with the HSA3400 system.
Programming
Learn in the keyfob as follows:
1
Enter learn mode as described.
2
Press the Arm button (ensure keyfob is
switched on). The keyfob LED will light and the
siren will beep to confirm.
3
Exit learn mode as described.
Arming and disarming
The system is armed by pressing the ARM
button for at least 1 second (this delay feature
prevents accidental opperation). The system is
disarmed by pressing the DISARM button in the
same manner. The switch at the side prevents the
keyfob from transmitting accidentally.
WARNING
Please note that when arming the
system with the keyfob, the entry/exit feature will
not be active. When the Arm button is pressed,
the system will arm instantly. Any activation of a
detector will cause an instant alarm.
Panic feature
You can cause the alarm to sound, regardless of
whether the system is armed or disarmed, by
pressing and holding down the Panic button. The
Panic button has to be pressed for more than 5
seconds to operate. This is a safety feature to stop
accidental operation.
Tamper disable/enable
The system tamper can be accessed with the
keyfob as follows:
1
To disable the system tamper, press the Arm
and Home buttons simultaneously until the
siren confirms (approx 5 seconds).
2
To enable the system tamper, press the Arm
and Panic buttons simultaniously until the siren
confirms (approx 5 seconds).
System learn mode
The system learn mode can be accessed with
the keyfob as follows:
1
To enter learn mode, press the Panic and Home
buttons simultaneously until the siren confirms
(approx 5 seconds).
2
To exit learn mode press Disarm, the siren will
confirm.
www.ukpanels.com