Yale GDP100VX, Service Manual

Page: 5 / 57

General
WARNING
The lift truck must be put on blocks for some
types of maintenance and repairs. The removal of
the following assemblies will cause large changes
in the center of gravity: mast, drive axle, engine
and transmission, and counterweight. When the
lift truck is put on blocks, put additional blocks in
the following positions to maintain stability:
• Before removing the mast and drive axle,
put blocks under the counterweight so the
lift truck cannot fall backward.
• Before removing the counterweight, put
blocks under the mast assembly so the lift
truck cannot fall forward.
The surface must be solid, even, and level when
the lift truck is put on blocks. Make sure any
blocks used to support the lift truck are solid,
one-piece units. See the procedure How to Put Lift
Truck on Blocks in the Operating Manual or the
Periodic Maintenance section for your lift truck.
If additional engine repairs are necessary for lift trucks
covered in this manual see:
• GM 4.3L V-6 Engines 0600YRM1251
• Kubota Diesel 3.8L Engines 0600YRM1557
• Kubota Diesel 3.6L Engine 0600YRM1579
If additional transmission repairs are necessary for lift
trucks covered in this manual see:
• Powershift Transmission 1300YRM1129
• Powershift Transmission 1300YRM1529
• One and Two Speed Transmissions
1300YRM1569
This section contains the description of the frame (see
Figure 1 or Figure 2) and connected parts.
Procedures for removing and installing the
counterweight, hood, overhead guard, engine and
transmission, and exhaust system are found in this
section. Checks for the operator restraint system and
procedures for the repair of tanks and installation of
safety labels are also included.
0100 YRM 1243 General
1