2
Latch
Retractor engages
bolt tail(s)
Lockbody
Frame engages latchcase
Insert lockbody into door from outside making sure that
lockbody frame hooks latch case and retractor engages
bolt tail(s).
DO NOT FORCE.
(If lockbody does not
engage latch easily, check door preparation for errors.)
7. Install inside components.
A.
Slide inside rose support assembly onto lockbody
and tighten through bolts.
B.
Place black plastic bushing over push/turn button.
C.
Place rose scalp on rose support assembly aligning the
dimple with the notch. Rotate the rose scalp clockwise
to lock. Note: Repeat on outside rose if necessary.
D.
Install lever handle. For double cylinder functions,
install the inside cylinder and lever as shown on the
next page.
Machine Screw
Inside Rose
Support Assembly
Set Screw Hole
Push/Turn Button
8. Strike installation (Wood Frames Only).
A.
Close door and mark a horizontal line from the center of
the template to the frame of the door.
B.
Measure half the thickness of the door. Mark this same
distance with a vertical line starting from the stop side of
the frame and where both lines cross. Make a 1 inch
(26mm) diameter hole and 1/2 inch (13mm) in depth.
C.
Align the holes of the strike with the vertical line. Trace the
outline of the strike and mortise with 1/16 inch (1.6mm)
depth. Attach the strike with two screws (provided).
STRIKES
371
Standard Strike Box
14-5301-1033
Attaching Screws
81-2012-0416
#8-8-32x3/4"
Attaching Screws
81-2012-0620
#12-12-24x1"
497
Optional Strike Box
#202
STOP
TEST THE OPERATION OF THE LOCKSET
Cycle the lock in both the locked and unlocked positions. If lock
functions smoothly when door is open, but binds when closed,
check door and frame alignment. If problems are found see
Troubleshooting on page 3.
6. Install lock.
5. Adjust lock for door thickness (if necessary).
(Lock is packed preadjusted for 1-3/4" (44mm) doors. Available for 2-1/4" (57mm) doors upon request.)
To Adjust for Thicker Door
A.
Remove two (2) screws from outside rose.
B.
Slide outside rose away from lock body.
C.
Adjust rose plate to desired door thickness per illustration at right.
D.
Fasten outside rose to lock body with two (2) screws.
2" door
1-3/4" door
C
Slide plate
to disengage
2-1/4" door
A
B
Rose Scalp
Bushing
Inside Lever
An ASSA ABLOY Group brand
80-9150-0060-010 (11-16)
