Door Must Not Bind
Door Must Not Sag
Door Must Not Be Warped
Door Must Swing Freely
Troubleshooting
1.
Check door.
2.
Check hinges. They should not be loose or have excessive wear on
knuckles.
3.
Latchbolt will not deadlock.
Either strike is out of line or gap between door and jamb is too great.
Realign strike or shim strike out towards flat area of latchbolt.
4.
Latchbolt does not retract or extend properly.
Latchbolt tail and retractor not properly positioned.
A. Remove lockset. Look through 2-1/8" hole and verify latchbolt tail
centered between top and bottom of hole.
B. Remove latchbolt and insert lockset. Look through latch hole and
verify retractor mouth centered in hole. Adjust outside rose plate if
not. (See #5 on page 2)
C. Rebore holes if necessary to line up retractor and tail.
3
(Note:
Cylinder and Sleeve must be properly installed or
the security of the lock will be compromised.
)
DUMMY TRIM INSTALLATION
Secure the Rose Support assembly to the door using screws
and washers provided and install the rose scalp and inside
lever.
Machine Screws
Inside Rose
Support Assembly
Rose Scalp
Inside Lever
Washers
A.
Insert key and rotate 45° counterclockwise.
B.
Depress retainer with tool provided.
C.
Slide lever off lock. (Also applies to inside
lever of 5321LN or 4721LN Function).
This lockset is designed to provide the highest standard of product quality and performance. Care should be
taken to insure a long-lasting finish. When cleaning is required use a soft,damp cloth. Using lacquer thinners,
caustic soaps, abrasive cleaners or polishes could damage the coating and result in tarnishing.
Finish Care
TO REMOVE CYLINDER HANDLE
TO REPLACE OR INSTALL CYLINDER
Tailpiece
Cylinder Sleeve
Yale Cylinder
A.
Remove the sleeve from inside the shank or
from the old cylinder.
B.
Slide cylinder into sleeve.
C.
Rotate key 45° counterclockwise. Depress retainer
plate, push the handle onto the shank until fully
seated. Pull on handle to ensure properly seated.
5328LN, 5329LN, 5339LN, 4728LN, 4729LN
or 4739LN Functions Only
Adjust for Door Thickness
An ASSA ABLOY Group brand
80-9150-0060-010 (11-16)
