background image

READ ME FIRST!

 factory tracks

fixed point

fig. 1

fig. 2

1”

 

‡

Vehicle and rack system must have a minimum of 165lb load carrying capacity

 

‡

The following Yakima towers can potentially be used:  TimberLine, SkyLine,

RidgeLine, RailGrab (med. or large claw), ControlTower, LowRider, 1A Rain gutter,

BedRock, and Outdoorsman.

 

‡

Use with Yakima Round, CoreBar, or JetStream bars

 

‡

For factory tracks or fixed points (see figure 1), ensure roof does not deform when

heavy loads are applied 

 

‡

For vehicles with raised rails, position crossbars as close as possible to rail supports

 

‡

Crossbar spread must be between 26” and 36”

 

‡

Do not use Roof-Top Tent with any clamp type towers (including Q-Tower and

BaseLine) or RailGrab Towers with Small Claw or Pin Adaptor.

 

‡

Do not use with factory crossbars, they are too flexible

 

‡

Do not position mounting hardware more than 1” outside of Tower (see figure 2).

 

‡

Max distance from top of crossbar to to ground; SkyRise Small = 86”, SkyRise

Medium = 98”

 

‡

Do not install on cantilever rails, or rails without sufficient support (see figure 3).

 

;

Do have a friend or dealer help with installation.

 

;

Do use tent when parked on level ground.

 

;

Do remove tent when not in use.

 

;

Do dry tent before storage.

 

;

Do use tent on level ground.

 

;

Do close tent cover fully before driving away.

 

;

Do assist children on the ladder. 

 

;

Do close and secure cover before driving.

SOME DO’S AND DON’TS

(additional warnings are contained in these instructions)

 

:

Do not climb on your vehicle’s roof.

 

:

Do not use tent unless ladder is securely in place.

 

:

Do not allow more than one adult on the ladder at a time. 

 

:

Do not use tent in high winds or heavy snow.

 

:

Do not transport anything on top of closed tent. 

 

:

Do not use open flame nor cook inside tent.

WATCH 

FOR 

THESE 

SYMBOLS!

=

SAFETY –

 Keep safe by reading the important safety warnings included in the 

product instructions! Safety warnings are identified with this symbol.

=

STOP – 

Please read all important product notes in the product instructions to ensure 

proper installation or fit information. These notes are identified with this symbol.

FIRST OFF, THANKS!

Welcome to the Yakima family.  We appreciate your support and are confident that you’ll get years of solid 

performance from your new Yakima product.   Below are a few helpful hints to make sure that you have a great 

ownership experience. Please keep these instructions.

IMPORTANT FIT INFORMATION 

WARNING - DO NOT USE THIS PRODUCT ON A VEHICLE THAT IS INDICATED AS “NO-FIT”

The Yakima Fit List now includes approved SkyRise Fits for many popular vehicles. Updates and additions to the Yakima Fit List for 

Roof-Top tents are being made continually. 
Vehicles that we have seen and tested are designated as “FIT” or “NO-FIT” for SkyRise.  Fits for SkyRise are different than for other 

Yakima products.   

Please note that virtually all factory crossbars are too flexible for Roof-Top tents. So vehicles on the approved 

Fit list will still require a Yakima base rack system.

  If we have not tested your particular vehicle and rack system, you can use the 

checklist below to evaluate whether your vehicle and rack system may support a SkyRise.  

Remember: The checklist below is designed to be a guideline only and any installation 

not on our approved Fit list is at the sole risk and responsibility of the owner / installer.

unsupported rail

supported rail

supported rail

fig. 3

OK

OK

NOT OK

Summary of Contents for SkyRise












Reviews: