=
1033604D-9/27
WARNING: BE SURE ALL HARDWARE IS SECURED ACCORDING TO INSTRUCTIONS. ATTACHMENT
HARDWARE CAN LOOSEN OVER TIME. CHECK BEFORE EACH USE, AND TIGHTEN IF NECESSARY.
REMOVING THE RACKS
1. Mark tower location with marker or tape.
2. Unlock towers and open RailGrab covers.
3. Loosen claws (claw tightener).
4. Lift rack up and off (do not disassemble).
Now enjoy a refreshment… and read these important details about your new rack system.
FACTORY LUGGAGE CARRIER
If the vehicle is equipped with a factory luggage
carrier, it may interfere with some accessories.
ANTENNA
Antenna on the roof may need to be removed to
prevent interference with the rack or long loads.
Sunroof may interfere
with crossbars or
accessories.
USE CAUTION WHEN
OPENING SUNROOF.
SUN ROOF
Some longer loads may
prevent the rear hatch
from fully opening.
USE CAUTION WHEN
OPENING YOUR HATCH.
REAR HATCH
This product is covered by YAKIMA’s
“Love It Till You Leave It” Limited Lifetime
Warranty .To obtain a copy of this warranty,
go online to www.yakima.com or email us at
[email protected] or call (888) 925-4621
WeIGhT lIMITs
Not more than
165 lbs. (75 kg)
or no more
than vehicle
manufacturer's
rating.
THIS PRODUCT
(10 lbs. / 4.5 kg) (RAILGRAB 2)
(12 lbs. / 5.4 kg) RAILGRAB 4)
ANY ACCESSORIES
LOAD
K E E P T H E S E I N S T R U C T I O N S !
INSTALLING RACKS AGAIN
1. Open covers.
2. Clean rails and place towers at marked positions.
3. Make sure towers are seated properly, then tighten
claws (using claw tightener) close covers and lock.
PERFORM SAFETY CHECKS ON ALL TOWERS!
TECHNICAL ASSISTANCE
OR REPLACEMENT PARTS
Contact your dealer, visit
www.yakima.com, or call
(888) 925-4621
Monday through Friday,
7:00 AM to 5:00 PM, PST
REMOVE RACKS BEFORE ENTERING
AN AUTOMATIC CAR WASH.
MAINTENANCE
Use non-water soluble lubricant on screws.
Use a soft cloth with water and mild
detergent to clean plastic parts.
TIE DOWN LONG LOADS
Always tie down both ends of long
loads to vehicle. Failure to do so
can result in property damage,
personal injury, or death.
