M
1
M
1
1033430H-4/33
TIP: To center crossbar between towers after setting your measurement use this
technique. While pushing downward and rotating the crossbar, adjust the crossbar as
needed to the left or right. Double check your m1 measurement and adjust if necessary.
Set M1 and center bar.
Be sure to not
move the towers.
Tighten tower/bar assembly.
Snap the
covers shut.
Install end caps and correct pads.
keep the pads clean and
free of debris. Clean pads
as necessary, and keep
them clean by not setting
them on a dirty surface.
Attach correct pads.
Some vehicles require
different pads on front (m1) and rear (m3). Pad
letter is located in the center of each pad.
Pull the measuring tape tight to ensure accurate measurements.
Measurements must be accurate to within 1/8” (3.2 mm).
Label towers with front of vehicle stickers.
Label the towers.
snap
snap
Note: Set measurements on a flat surface away from vehicle.
fRONT Of VEHICLE
Will you be installing your Q-Tower pairs on the FRONT or on the REAR?
For FRONT installation continue below. For REAR installation skip to step 11.
5Nm
