28-13-355-Rev4
3/10
7
INSTALL MOUNTING BLOCKS
Place Mounting Block from Platform kit on top of each Leg assembly, lining up the
rivnut holes on Mounting Block with holes on tabs of Leg Mounting Bracket.
Secure with M6 Capscrews and Washers from Platform kit, as shown. Tighten all
screws to 4 Nm with a 4 mm Ball End Allen Key or suitable Torque Wrench.
Note:
The Mounting Block assembly will still have movement after securing which
is intended.
LEG LOCATION
Position front Legs onto the vehicle rail so that they are centred 55 mm from rear
of front door.
Recommended distance between centres of front and rear Legs is then 925 mm.
925 mm
55 mm
8
Push padded Foot Extrusions into
the rear cavity of LockNLoad Legs.
(When assembled onto a vehicle
these will click into position).
5
6
LEG ASSEMBLY
Slide the Claw assembly into the
LockNLoad Leg, as shown.
Insert the M6 bolt and washer from
the Leg kit into the Leg and wind
(six revolutions) into the grip plate.
