28-13-356-Rev1.0
3/9
Push padded Foot Extrusions into the
rear cavity of LOCKN’LOAD Legs. (When
assembled onto a vehicle these will click
into position).
5
6
LEG ASSEMBLY
Slide the Claw assembly into the
LOCKN’LOAD Leg, as shown.
Insert the M6 bolt and washer from the Leg
kit into the Leg and wind (six revolutions)
into the grip plate.
8
PIVOT ASSEMBLY
Assemble as shown. Loosely tighten the M8
screw and ensure a suffi cient gap remains
between Nut Plate and Leg to allow Bar to
slide through in next step.
7
INSERT LEGS
Slide Leg Assemblies into the underside
channel of each of the LOCKN’LOAD Bars
(sold separately).
BAR LOCATION
Look for the factory pin holes on the roof rails. For the front Bar, we recommend using the hole
closest to the front of the vehicle and for the rear Bar, the hole closest to the rear of the vehicle.
Bar spacing should be approximately 800 mm.
800 mm
9
