28-13-004-Rev4
5/8
SECURE END CAPS TO BARS
Insert the End Caps as shown. A Rubber
Mallet can be used to assist installation.
Secure using Plastite Screw
(from LockNLoad Bar kit).
Tighten using a #2 Phillips
Head Screwdriver.
12
13
BAR FITMENT
Carefully place Bar assembly over Pads.
Take care not to damage vehicle.
Once positioned, locate the raised notches on base of
Legs into the recesses on Pads. Repeat for all Bars.
14
BAR SLOT COVERS (OUTSIDE LEG)
Measure the Bar channel outside of the Legs and subtract 20 mm from this
measurement. Using the remaining pieces of Slot Cover from Step 9, cut to
this length and insert into the underside channel of each Bar end as shown.
-20 mm
11
